There are strict requirements on the specifications of the switching switch. Before you choose, you should know the specifications of the switching switch, so as to make the switching switch more suitable for our use. The following is a detailed introduction.

Dial switch, also known as sliding switch, can be widely used in computer mouse, automobiles mouse, automobiles electronic products, communication equipment, military products, testing instruments, gas water heater, gas stove, small household appliances, microwave oven, rice cooker, floating ball equipment, medical equipment, building automation, electric power. Toggle switches in tools, general electrical and radio equipment and other fields have been widely used in the above fields. Although small, they play an irreplaceable role.

The classification of the switchgear products: vertical, horizontal, plug-in, patch, two, three and four.

Electrical performance of the switch in various aspects:

Rated power: DC50V0.3ADC6V0.5A

Work range temperature: - 20 ~60

I. Electrical Performance Specifications

1. Contact resistance test: Requirements: must be below 30 milliohms.

Test under the micro current (100mA).

2. Insulation resistance test: Requirements: Must be more than 100 megaohms.

Input 500VDC voltage for 1 minute and test according to the following contact method:

(1) between the plastic body and the pins (2) between the pins which are not in contact with each other

3. Voltage withstanding test: Requirements: No abnormalities such as insulation damage.

Input AC 500V (50-60Hz) voltage, 1 minute induction current is 0.5mA, press the following

Contact method test.

(1) between the plastic body and the feet. (2) between the feet without contact

II. Mechanical Performance Specifications

1. The routine motor force is 250+_50gf.

2. Terminal Strength

Strengthen the front end in any direction (500gf) for 1 minute.

There were no abnormalities such as splitting and dodder movement in the feet.

Requirements: Meet the mechanical and electrical performance.

3. Test Standard State

The test temperature, humidity and air pressure are as follows:

(1) Temperature ranges from 5 ~35.

(2) Humidity is 45%~85%.

(3) Pressure 80 Kpa~106 Kpa

3. Durability

1. Weldability test

The top of the terminal is immersed in a tin soldering pool at a depth of 1 inch, and the temperature is 230 (+5 C) for 3 (+0.5 seconds).

Be careful:

(1) Welding time should be less than 3 seconds

(2) The welding area should be more than 80%.

2. Welding resistance test

The temperature of the welding furnace is controlled at 260 (+5 C), the time of passing the furnace is 3 (+0.5 seconds) and the thickness of the substrate is 1.0.

The temperature of hand welding should be controlled at 320 +5 C for 3 +0.5 seconds.

Requirements: Must satisfy the body without deformation, meet the mechanical and electrical energy.

3. Life Testing

No-load: The operator performs 10,000 no-load tests at frequencies of 15-18 times per minute.

Requirement:

(1) Contact resistance should not exceed 200 m_

(2) Other, satisfied with mechanical and electrical properties.

4. Heat Resistance Test

After 96 hours of testing at 85 +2 C, it was measured at normal room temperature for 1 hour.

Requirements: No abnormal appearance, meet the mechanical and electrical performance.

5. Cold Resistance Test

Place it at 40 2 C. After 96 hours of relative humidity in 90-96% environment,

The samples were put in normal environment for 1 hour and then tested.

Requirements: No abnormal appearance, meet the mechanical and electrical performance.

6. Moisture test

Place it at 40 2 C. After 96 hours of relative humidity in 90-96% environment,

The samples were put in normal environment for 1 hour and then tested.

Requirements: No abnormal appearance, meet the mechanical and electrical performance.